午夜嘿嘿嘿影院_自拍少妇综合在线观看_波多野结衣喷水最猛一部_亚洲午夜一区二区在线观看_先锋影音国产在线_又大又黄又爽视频免费_4d玉蒲团奶水都喷出来了_老外一级毛片免费看_24国产欧美亚洲精品第二页_国产精品无码久久忘忧草

Contact Us

Cooling Fan Manufacturer conservation methods

Date: 2014-10-28   Click: 1404 Times

"Cooling Fan Manufacturer" from the inside of the motor in terms of its internal protection devices, there is a thermal breaker that is part of the coil windings short-circuited, causing a sharp increase in heat, breaker circuit, the motor this case, the general strike . This rarely happens. Another is to start capacitance becomes smaller, although the nameplate reads those parameters, but a long time, the capacitance is reduced, resulting in smaller starting torque of the motor, can not drive the load. This simple, remove the "Cooling Fan Manufacturer" capacitance, go for a new, same model should be no problem. But the best for a 20 percent larger than the original, and will get better results. The motor shaft axial gap is too large will cause can not drag the load. If it is demolished motor, shaft axial gap is too large to be adjusted by adjusting shims. When installing the motor, the rotor must be concentric with the bearing for the job, slowly tightening the screws diagonally want, and then use a screwdriver to knock wood shaft, making concentric. Demolition "Cooling Fan Manufacturer" motor is simple, but putting it back on again is not casually pretend to go back, do not occur above case, otherwise, direct repair "bad".

Back to: Industry news

+86-0769-83660708

Home Product News Contact